网站导航

新闻中心

当前位置: 主页 > 新闻中心
如何解决进口电磁阀通电后不工作的方法
时间:2020-07-14 21:38 点击次数:
 进口电磁阀在工作时也会有状况发生,这些状况的发生很多时候会耽误生产和工作,严重的甚至会造成经济损失。随着我国对此类产品需求不断增大,对相关可能出现的问题也要引起更多重视。对于进口电磁阀来说,进口电磁阀通电后不工作的解决办法有哪些呢?接下来我们就以著名的进口电磁阀品牌德国洛克为列,让德国洛克的技术人员为大家讲解一下有关进口电磁阀
 
1、检查电源接线是否不良:
 
    重新接线和接插件的连接检查电源电压是否在±工作范围,调致正常位置范围线圈是否脱焊,重新焊接线圈短路,更换线圈工作压差是否不合适,整压差,或更换相称的电磁阀流体温度过高,更换相称的进口电磁阀有杂质使电磁阀的主阀芯和动铁芯卡死,进行清洗,如有密封损坏应更换密封并安装过滤器。
 
Rewire and connect the connector, check whether the power supply voltage is within ± working range, adjust the normal position range, whether the coil is desoldered, whether the coil is short circuited, whether the working pressure difference of the replacement coil is inappropriate, the integral differential pressure, or the fluid temperature of the corresponding solenoid valve is too high, and the corresponding solenoid valve has impurities, which causes the main valve core and moving iron core of the solenoid valve to be stuck and cleaned, If the seal is damaged, replace the seal and install the filter.
    
2、进口电磁阀不能关闭
 
    主阀芯或铁动芯的密封件已损坏,更换密封件流体温度、粘度是否过高,更换对口的电磁阀有杂质进入电磁阀产阀芯或动铁芯,进行清洗,弹簧寿命已到或变形,就需要更换,节流孔平衡孔堵塞,及时清洗,工作频率太高或寿命已到,改选产品或更新产品.
 
If the seal of the main valve core or moving iron core has been damaged, whether the fluid temperature and viscosity of the replacement seal are too high, the impurities of the replacement solenoid valve enter into the valve core or moving iron core of the solenoid valve for cleaning. If the service life of the spring has reached or is deformed, it needs to be replaced. If the throttle balance hole is blocked, clean it in time. If the working frequency is too high or the service life is up to now, the product should be changed or updated
 
    3、其它情况:
 
    内泄漏:检查密封件是否损坏,弹簧是否装配不良
 
    外泄漏:连接处松动或密封件已坏;紧螺丝或更换密封件通电时有噪声;头子上坚固件松动,拧紧。电压波动不在允许范围内,调整好电压。铁芯吸合面杂质或不平,及时清洗或更换。
 
    一类产品的使用不可能都是一帆风顺的,随着对产品使用不断深入,产品可能暴露的问题概率也逐渐增加。对于进口电磁阀来说,它已经有了比较好的发展底蕴,相关问题的出现也已经有了比较好的解策,对于商家来说,给消费者提供更好的产品保障是非常重要的工作。对于产品可能出现的问题,应该有更好的预案和准备。目前我们生活中各行各业都有用的到进口电磁阀比如:电站、冶金、建筑、锅炉、设备、管道、热能、空调、消防、给排水、水处理、石油化工、造纸印刷厂。
如何解决进口电磁阀通电后不工作的方法(图1)

如果您有任何问题,请跟我们联系!

联系我们

Copyright © 2020 莱恩泵阀制造(珠海)有限公司 版权所有 备案号:粤ICP备20030173号-1 XML地图 技术支持:125网络主机

地址:珠海市前山港昌路598号2005商铺之一

在线客服 联系方式 二维码

服务热线

13824185985

扫一扫,关注我们